Usually the cause for that kind of thing is that everyone around you is using the same type of wifi on the same channels, because routers are dumb and nobody knows enough to switch channels. Various options are to switch to a different wavelength... try using 5ghz instead of 2.4ghz. The benefit (and detriment) of the two is that 5ghz carries more data, but has more problem penetrating through walls and stuff. So... less interference from your neighbors, higher bandwidth... but as you go through walls in your own house the bandwidth drops off. 2.4ghz tends be more over-used, penetrates further (the frequency controls that), but has lower bandwidth (frequency again).
If you bump up your signal strength with a stronger router or better antennas, you can drown out your neighbors, but then you're fucking with their bandwidth and reception. And... as mentioned previously... you can change channels... been awhile but the 2.4ghz spectrum covers a few channels, with each channel being around 20mhz in range.... so there are 11 available channels. Most routers come pre-set to specific channels, so those ones tend to be overloaded. If you swap to an under-utilized channel, the issues go away. At 5ghz, apparently channels sizes vary... but the same concept applies. Whatever other people use, you should avoid.
There are free apps you can download that can scan channel usage to see what's available. I've used the following, mostly for curiosity's sake:
Anyway... hope that helps.Statistics: Posted by Satis — Tue Dec 08, 2020 8:56 pm
]]>